In order to comply with DOT and SAE standards these DRL bars have to be dimmable. There is a second power wire located on the wiring harness that can be wired to a low beam. Once the low beam turns on, the LEDs will dim by 50% Also it is possible to wire into the turn signal to have the units dim so the turn signal is much more noticeable. Our C6 LED DRL Lights are designed to plug into the factory connectors for the stock fog light harness. Assembly includes all necessary connectors, rubber seals, and pigtails for a plug and play install.No error codes, no flickering, hyper-flashing, or radio interference. (Driver Side & Passenger Side). Plug and Play into your OEM fog lamps harness. General Installation Guide & Tech Support Available. All our products meet the IP international protection codes IP69K and IP67 respectively classifying them as water and dust proof to the extent they are high temperature washdown safe and submersible. Electronic components are to be found everywhere in vehicles today and these often sensitive components must be kept free of electromagnetic interference. Lights meet EMC CISPR level 5 which is higher than the most commonly required automotive standards. Since its foundation in 1905 SAE International has developed engineering standards that have been recognized and adopted globally. This LED DRL Unit meets SAE J2139 that defines environment standards and tests for vehicle lighting systems. We have confidence in the reliability of our products, they come with a 2 year guarantee. You have further assurance that a LightWurkz® products will not let you down. This applies only to internal damage, not the damage caused by normal wear and tear such as broken glass. We recommend to apply clear film to protect the glass lenses from the rock chips. Bumper removal is not required. Elevate car on jacks, turn wheels, and remove fender liner push clips and screws.
Installation time is approximately 1-3 hours depending on experience and tools.